The process of using the heat shrinkable packaging machine, not only creates economic benefits for us but also has certain losses. Therefore, like mechanical equipment, its maintenance must be done well. In this way, its service life and work efficiency can be improved. Here is how to do the daily maintenance of the heat-shrinkable packaging machine.
The daily maintenance of the heat-shrinkable packaging machine is very important. We should carefully carry out various maintenance operations to reduce the damage speed of parts and avoid the chance of failure, so as to increase the service life of the equipment. First of all, it is suggested that the machine maintenance personnel must regularly maintain the shrinking machine of the heat-shrinkable packaging machine because this place is very important. Therefore, after we stop working every day, the blade must be cleaned and maintained with a wire brush and film remover to ensure the cleanness of the blade. In particular, the moving parts of the heat-shrinkable packaging machine must always be lubricated to keep the movement smooth and reduce resistance. Only by doing this well can we reduce the problems of the equipment during operation. Of course, it is also recommended that you regularly conduct a comprehensive inspection of the equipment, and properly replace the ageing or severely worn parts. In addition, the power value of the heat-shrinkable packaging machine is also good. We should pay special attention to the notes on the nameplate of the shrinking machine of the heat-shrinkable packaging machine. Here, we suggest that the power input power during its specific operation must be less than or equal to the notes on the nameplate, so as to reduce the long-term overload operation of the equipment. The purpose of this is to prevent the internal circuit or equipment components from burning due to overheating and ageing.
The above are the maintenance methods of the heat-shrinkable packaging machine. Ensure that the operator studies before taking the post. In this way, the chance of equipment problems can be reduced. Strictly observe the operating procedures of the heat-shrinkable packaging machine. In the power-on environment of the heat-shrinkable packaging machine, ventilation shall be carried out before power is on, and the power supply shall be turned off before gas is cut off when the machine is shut down. Of course, we should also pay attention to its environmental conditions. Because it should be used in an environment where the temperature is -10 ℃ - 50 ℃, the relative humidity of the air does not exceed 85%, and the surrounding air is free of corrosive gas, dust and explosive hazards. In addition, the placement position of the heat-shrinkable packaging machine should also pay attention to ensure the levelness of the equipment surface, so as to ensure the normal operation of the electric heating pipe and ensure its service life. If the mesh belt transmission equipment is not installed at a good angle, it will cause the deviation of the centre. It is necessary to regularly fill the gear mesh, bearing oil hole with seat and moving parts with engine oil for lubrication. Once per shift, make sure it is the same every day. Only these routine maintenance and inspection can prolong the service life of the equipment and improve its reliability of the equipment,
The above is about the maintenance tips of a heat-shrinkable packaging machine. If you still don't understand anything, please call whatsapp:008613717481755. That's all for today's knowledge. I hope it can help you. The next issue will also bring more information about the packaging machine.